Fillings With Magnet For Warhammer Miniature Bases (25/28/32/40mm)

This is set of fillings that enhance default bases of warhammer miniatures. It fits exactly into the “empty” space in the base and contains dedicated space in the middle for magnet placement.

Size of supported magnets are 3 or 5 mm in diameter with 1mm thickness. It's the most common type you can get on Amazon as well asi standard sizes of Army Painter's magnets. Bottom floor of model is only 0,4mm thick and magnet can comfortably hold miniature (tested with Army Painter). Of course use bigger magnet for bigger model. ;)

Thickness of the empty space under base fluctuates between 2 and 3 mm therefor there is enough space if base has a hole to hold model - as in the case of Tyranid in the pictures. It also gives an option not to use permanent solution like super-glue, but instead opt for double-sided 3M like tape. Just place it over magnet - it should hold reasonably well and there is still option to separate filling from base.

Don't forget to make sure your magnets have proper orientation if you want to use counter magnet for holding of miniature instead of metal.

Printing:

0.2mm, no supports needed