Nerf Rival Pathfinder XXII-1200 Sight Replacement

These replacement sights don't cause damage to the blaster and does not require the entire shell to be removed during assembly.

Parts include a blank sight (to completely remove the barrel sight), a low profile iron sight and a less intrusive iron sight that mimics the original.

PRINTING:

Recommended to print with PLA or PETG.

.3mf files included in the .ZIP

Note:

• the “leg” that supports the overhanging feature should be cut in half with flush trim snips (see images)
  • The remaining part of the leg that is still attached to the overhang afterwards will slot into an exposed notch at the base of the sight assembly.

INSTALLATION:

1. Remove the pump
2. Remove the the 5 screws holding around the barrel (see image)
3. Pull up on shell near sight and remove the original green sight
   • Careful not to pull so hard as to break the plastic - it does not require much space to remove the sight
4. Replace the sight with the new printed part
   • If inserting the blank sight keep in mind the orientation of the part. The “leg” should fit inside the notch towards the rear of the original sight assembly.
5. Replace screws & pump

Please visit our Etsy shop to see what else we do!

https://kettlefishcreations.etsy.com