When using the Augury spell your DM is supposed to tell you if good or bad things are going to happen with “Weal, Woe, and Weal + Woe”. I wanted to have some fun cards that would stand up to the occasional spillage so I made these.
To get the exact look I made here are the instructions:
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Matte Sakura Pink Transmission Distance: 3
PLA BambuLab Matte Ivory White Transmission Distance: 4
PLA+ Sunlu Skin Transmission Distance: 5
PLA BambuLab Matte Sakura Pink Transmission Distance: 3
PLA BambuLab Matte Ivory White Transmission Distance: 4
Settings:
.04mm nozzle
.08mm Layer
.16mm First Layer Height
100% Sparse Infill Density
Rectilinear Infill Pattern
Swap Instructions:
Start with Charcoal
At layer #10 (0.88mm) swap to Red
At layer #14 (1.2mm) swap to Sakura Pink
At layer #17 (1.44mm) swap to Ivory White
At layer #18 (1.52mm) swap to Skin
At layer #19 (1.6mm) swap to Sakura Pink
At layer #20 (1.68mm) swap to Ivory White for the rest.
The author remixed this model.
Turned the vector art into an STL with Hueforge and edited it to make it relevant to the Augury spell