DJI Avata Motion Controller Stand (v1 or v2)

The DJI Motion Controller is awesome, but if you need to set it down for any reason, it sends your drone into a flat spin.  Slip it on your controller and voila - you can set it down and it remains vertical.  

It's a nice tight fit, based on a scan of the controller and designed to stay on all the time without glue or anything.  There is a hole in the back so you can charge without removing the stand.  

I printed it in ASA, but tough PLA works well too.  I used .2 layer height, 4 perimeters @ .6 width, 15% infill and 1.2mm top and bottom minimum thickness.  The rear hole prints better with a little support, and I painted the seams to follow the controller seams (you'll see them in the model).