Viper Valve Index Stock REMIX 15mm tubing

A remix of the Viper Valve Index VR Stock to work with 15mm tubing.
1
29
0
169
updated January 4, 2024

Description

PDF

Hello!

 

This is a remix of the Valve Index Viper Stock by fletcherkinnear on Thingiverse (https://www.thingiverse.com/thing:5362506) 

 

I have modified the parts to accept 15mm tubing between them. You will need about 50cm of tubing. Start with a bit too long tubes and cut them to fit your ergonomics until you feel comfortable.

 

 

These knuckles are fabulous and fit great with the index controllers. I cannot recommend this design enough. Look on the thingiverse original upload (https://www.thingiverse.com/thing:5362506) for more information, from the actual creator. I have merely adapted the design to fit the tubing I had at hand.

 

I would suggest to scale the model to 102% to better fit the controllers and easier accept the tubing. If the tubing goes in too easy after scaling, heat it up before finally seating it or use glue.

 

The butt and front grip can be printed on the side without much supports.

 

The rear grip needs supports. 

Tags



Model origin

The author marked this model as their own original creation.

License