UPDATED: Bambu glass top spacer - vent holes and no vents, holds LED LIGHTS

These should be printed in ABS due to heat…PLA will warp and sag over time..

2 different sets, with and without vent holes, they interchange so you can just have holes in front or rear or both or none.. i find the vent holes DO NOT EFFECT PRINTING quality but has prevented the issue of a clogs with higher bed temp with abs when you run 110c on bed also no more need opening door or removing cover with PLA, this has been helpful in so many ways.

the space between the glass 27mm higher, help lower heat at top, help give a much smoother angle for the PTFE tube, works for the Bambu USB LED kit and others, holds glass and lip is only 2.5mm so it don't stick up above the glass so edge won't get broke off, also help prevent having a small short piece breaking off in the extruder and tube when retracting.

LED light kit from Bambu are long, you can make 1 or 2 or 3 turns, i choose it greatly increase the brightness of the far side of the bed to see better when printing, also the TH3D kits will install on these or you can make your own as i have

IF INSTALLING LED Light kit, use some hot glue or super glue to hold wire at the end of the strip.. i used hot glue, works fine.