Hello everyone,
Here is my version for monitoring the extrusion diameter.
I chose this position because there are no notches on the filament due to the pulling knurled wheel and the filament should already be hard enough.
Setting / Use
To set the dial gauge to zero, simply press the reset button without material.
Alternatively, it would also be possible to use a piece of filament with exactly 1.75mm as a calibration standard and then set it to zero, then it would be o idel and you could see the deviation through - and + values.
I will publish the other changes separately.
- modified housing
- modified material container
- additional lid/cover
- additional handle for the lid/cover
BOM:
2x ball bearing 10x4x3 https://amzn.eu/d/6FcR58o
2x Slot nut 8mm /M4 https://amzn.eu/d/1PkedTI
2x Cylinder head screw M4 / 10mm
1x Cylinder head screw M3 / 20mm
1x Cylinder head screw M3 / 10mm
1x Cylinder head screw M4 / 16 or 20mm
1x Nut M3 (recommended self lock nut)
1x Nut M4
1x Measuring probe for example Mitutoyo
1x Countersunk head screw for Mitutoyo M2.5x045 / 8 or 10mm
1x haltebuegel_100 (printing part)
1x messuhr_halterung_100 (printing part)
1x messuhr_halterung_2_100 (printing part)
Printing setting:
0.2 mm layer height
5 Wall lines
5 upper layers
5 lower layers
35% infill
Printing Material Material:
ABS, PETG (recommended)
please visit the inoficial Artme 3D group:
https://www.printables.com/de/group/filament-extruder-artme-3d-mkx-mQYMaAQ/comments
Special thanks to Artme3D Developer David Pfeifer for providing the models.
The Original Desktop Filament Extruder from ARTME 3D is a small but powerful desktop device that allows you to produce your own filament or recycle 3D printing waste. You can find the complete documentation and the corresponding kit on.
Link to the webpage: www.artme-3d.de
Link zu den Printabel Modellen
https://www.printables.com/de/model/524363-original-desktop-filament-extruder-mk2-by-artme-3d
if you want to keep me awake, feel free to buy me a coffee ;-) https://paypal.me/saiboTTech
The author marked this model as their own original creation.