FLSUN super racer with Bambu hotend and Bondtech LGX Lite extruder
Updated Added grille exhaust for best air guide. The grille diverts air away from the bed, especially helping with enclosed prints.
Added house fan3010 "David version"
This is a more compact and lighter configuration than the direct drive version V6 hotend with the LGX lite. The center of gravity on the effector is more optimal when lowering the motor position
Use the original fans
The height of the nozzle is very close to the bed calibration sensor support, it still needs to be verified that it can be used at the same time, but I have made the design so that it is easy to dismantle this support if necessary
The house use M3 inserts of OD4.5mm Length 3mm for fixing the bamboo heatsink and for fixing to the effector plate
The fans are threaded direct plastic housing
Testing Video: https://youtube.com/shorts/VM8bInxmK1Q
Printer Brand:
Flsun
Printer:
Flsun Super Racer
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
30%
Filament: any ASA or ABS any
Category: 3D Printer ExtrudersThe author marked this model as their own original creation. Imported from Thingiverse.