Endstop mod for Voron 2.4r1 mgn9 CW2 X carriage

This uses the usual KW10/KW11/D2F size switches.

Re-made X carriage endstop mod for the v2.4r1 + cw2 mount on mgn9 because the one I found at https://www.printables.com/model/662739-voron-mgn9-endstop-carriage-cw2 does not have holes that fit regular Voron-size heat set inserts nor a channel for running a wire without pinching on my current Z probe.

Also includes a cut-out for routing the endstop wires up the center channel if something is blocking the hole (inductive probe, or an adapter that fills up the space).

The X endstop switch must be installed with the lever angled like |/ rather than |\ otherwise (like how the images show the orientation), the switch will not activate when homing. The trigger is super close to the end of travel, so you might have to bend the lever outward a little if the endstop does not trigger when homing.

Next revision will have a better pocket for routing the wires, when showing in my quickdraw probe adapter, it still has to rub against the endstop wires tightly. It works, but I don't like it.

• Add endstop cut out
• Add wiring routing cut out
• Re-locate rear thread insert to front