Created the Simpsons logo from the show. I didn't want a back plaque piece so I moved the “SI” closer to the M to connect and dropped the word “the” down on top of the “p” and “s” so it wasn't floating.
The model is 20MM thick so it can stand on its own, but if you want more of an art piece slice the back 10mm off.
This was printed on a single color E3 Max Neo with a color swap from black to yellow but you will have to look at the layer line in your slicer to see the swap as the printed model shown was blown up to 150% from the original design.
I used a 15% infill, but after watching it print especially at the swap area, I would suggest bumping that up to at least 20% as I had one area where the black cover layer started falling through the infill due to being open by a wall.
**** Please note that the model in the picture ended up having a small leak in my heat break and didnt see it until the yellow was almost finished, so there may be a splotch in the picture but that is on my end of the printing.****
The author marked this model as their own original creation.