Jordan 1 Finger Toy, both shoes, no support

I was scrolling through the ‘Finger toy’ competition when I saw that the most downloaded model competing was a Jordan finger toy so I went to check it out and download it. I soon realized a few things firstly it needs a brim and lots of small bit of support which I found unnecessary and very fiddly, I soon also realized it was only one shoe,  which, in my opinion, is a bit pointless, although you can mirror it is still a bit annoying.

So, determined, I found this 3D scan of a Jordan 1 by rtql8d, sadly like most 3d scans this was not meant to be printed, so I repaired, filled, mirrored and flattened the shoe and after a lot of glitching this is the final product, a care free set of Jordan 1's that print without any fancy setting and are ready straight off the build-plate I have also designed them to have a logical amount of detail to make sure your printer doesn't stress over unnecessary details.

The finger hole size is 18mm which fits me perfectly as an average 14 year old boy but if you have any problems with the model or need a bigger/smaller finger hole just leave a comment and I will get to you as fast as possible, or you could just scale it up/down to fit your fingers.

Enjoy :)

A lot of patching, flattening and filling to make it printable.