Fox & Hen [Board Game] (or Fox & Geese)

Fox and Hen is a board game for 2 people with 20 hens and 2 fox figures

You need:

• 1x Grundplatte_Groundplate.stl
• 4x Grundplatte_Sideplate.stl
• 20x ceramic_rooster_5x5x35mm_hole.stl
• 2x fox_5x5x35mm_hole.stl
• 33x Magnet_Stopl_plug.stl (to trap the Magnets in the board)
• at least 22 Magnets Ø5x3mm for the play figures

Example: (https://www.gearbest.com/classic-toys/pp_443267.html?wid=21)

• at least 33 Magnets Ø8x1mm for the board

Example: (https://www.gearbest.com/classic-toys/pp_443271.html?wid=21)

.

When you push the magnets into the figures, make sure they all have the same polarity - or they will get repelled :)

The magnets at the board are easily changeable/removable thanks to the tight-fitting plugs.

.

------------Fox & Hen------------

.

RULES

The hens start the game. The hens move forward and to the side, but not diagonally or backwards. Allowed is one movement per round. The fox can pull in any direction, straight or oblique to all sides. The fox can "eat" hens. A jump is valid when the fox is standing directly in front of a hen and the field behind it is free. The skipped hen is removed from the game. Serial jumps are allowed. If there is a jumping possibility, the fox must jump. If he does not use them, he is removed from the game. However, he is used again any place when the other fox has jumped (eats a hen). The hens have won when all 9 fields of the target square (the top nine fields of the game board) are occupied with hens or when the fox can no longer pull. The fox has won if there are only 8 more hens in the game or they can not pull.

more detailed rules: https://boardgamegeek.com/thread/1233091/2-foxes-20-hens-how-play-fox-and-henschickens

.

------------Fox & Hen------------

.

• The magnet-hole.stl is if you want to make custom figures & want to use the same magnet size.
• at a later date, I will add a top so you can close the "cube"...

.

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

Yes

Resolution:

0.3

Infill:

25

Notes:

0,3mm layers for the board
0,1mm for more detailed figures

Color change on the board; the holes and slits are 1,2mm deep.

1,2mm ÷ 0,3mm layer height = 4 layers (in top color)

After printing the board pieces, lube the joints a bit and force them together. They will snap in.

.

Figures printed in PLA

Game Board printed in FormFutura HDglass (PETG) transparent red & transparent green

App version :)

Since this app was developed by fellow country(wo)men...