Created some parts to turn https://www.printables.com/model/557480-classic-lantern
into a street light for a New Orleans themed birthday party.
Non-printed parts required:
Printed parts not included in this file:
Printed parts included in this file:
Instructions:
Printed everything in Overture PLA Professional (or PLA+). .2 layer height and used supports for the candle holders and knobs.
Candle holders designed for these candles: ( https://www.amazon.com/dp/B07D54VFZN?ref=ppx_pop_mob_ap_share ).
Used 1 small screw through the candle hold of choice, then the lantern bottom and into the 1 ½ inch PVC cap. Cut the 1 ½ inch PVC to desired length. Slide the base top up from the bottom of the 1 ½ inch pole, then the 4 inch PVC and finally line the 1 ½ inch pole up with the insert on base bottom piece and push all together. You can glue or silicone the base to the bottom and add sand or other medium to add weight if desire. Mine was fine without it. Then screw 3 or 4 of the shelf brackets to the base for support. It did stand on its own but I added the feet to make it more stable outside.
The author marked this model as their own original creation.