Angel Pikachu FanArt - Christmas Tree Decor/Ornament/Bauble

Angel Pikachu fanart christmas tree decor/ornament/bauble I modeled and sculpted in blender then 3d printed and painted. I successfully 3d printed this model without supports. It is very easy to assemble: the wings are fitted to the slots the at back of pikachu.

features:
✅ no support
✅ easy to print
✅ easy to assemble

Note: for personal use only. Do not sell or distribute my STL's

Let's connect ;D
Show me your makes of my models. Say hi and connect with me at fb/IG/twitter/TikTok: zirenspar

Settings Guide
• no support
• nozzle diameter: 0.40-0.60mm
• infill: 10% lightning mode worked for me on pikachu
• infill: 20% lines for the wings on my test print. could be lower, just make sure there's enough support for the top layers of the wings.
• you might need to use brim to ensure the pikachu model sticks to bed

I used 0.16-0.20 layer height on my test prints without supports. Please use adequate cooling to ensure the ears can be printed smoothly. Check lift head or slow down for layers lower than 10 seconds for adequate cooling.