Creality K1 - Door Opening Cover (remix)
I made a small adjustment to @Henlor's design, printed his as is, and found the door would not close.
16
168
0
1146
updated July 3, 2024
Description
PDFPrint this part as orientated; no supports are required.
Get the other STLs from Henlors post, along with installation instructions.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Trimed 1.5mm from the top and left edges. The door now closes without any contact other than to seal the opening. No need to reprint the hinges to accommodate the original main part.
