External Filament Holder FlashForge Inventor Dreamer

The gbzh01 remix didn't support the rod that I had available, so I recreated it from scratch using his as a reference.…
0
12
0
150
updated December 21, 2023

Description

PDF

The gbzh01 remix didn't support the rod that I had available, so I recreated it from scratch using his as a reference.

This new version has a 22.5mm diameter hole to support a 3/4in dowel or standard bearings.

The chamfer is only on the outside of the stands so that it prints clean and flush on the bed.

Fusion360 and OBJ files are uploaded.

Print Settings

Printer Brand: FlashForge
Printer: Inventor
Rafts: No
Supports: No
Resolution: 0.20mm
Infill: 20% Gyroid
Filament: Inland PLA+
Notes:

Printed flat from S3Dv5 using adaptive layer heights (0.1 to 0.3) at 100mm/sec.

How I Designed This ===================

Designed in Fusion 360 after printing gbzh01:2217644 remix. Rough measurements were taken of the main body and then sketched onto the plane.

The circle in the sketch was used only as a reference point for the body reduction.

Once the sketch was extruded (7mm) a 22.5mm hole was added to support standard bearings.

Fillets were added to all stress points for increased strength.

Chamfers were added for aesthetic.

Lastly, the body was mirrored to create the right side as the sketch was for the left.

Left side sketch

Tags



Model origin

The author remixed this model. Imported from Thingiverse.

Differences of the remix compared to the original

This new version has a 22.5mm diameter hole to support a 3/4in dowel or standard bearings.

The chamfer is only on the outside of the stands so that it prints clean and flush on the bed.

License