PS5 Side Panel Logo Insert

Print in resin for most accuracy. I have not tried using a filament printer, so if you do, good luck! :) , (SEE SUMMARY)
9
114
0
470
updated December 18, 2023

Description

PDF

The print as shown in the pictures is printed in resin on my Elegoo Jupiter, with Sunlu Clear Resin Standard that has been tinted orange using resin dyes.

The bottom layer, (where you can glue if you want, may or may not be needed), is .500 thick to help keep it flexible for pushing into the side panel, (the curvature can be very hard to match, again, depending on printer).

It is a tight fit for sure.  For the panel I was working on, I couldn't scale it bigger or smaller.  If I went bigger, the outside of the logo would hit.  If I scaled smaller, the thin black pieces of the logo wouldn't fit inside the print. It is a very fine line between what will work or not.  You may, (probably will), have to do some trial and error as far as scaling to work for your printer.  So please no negative comments saying it doesn't fit :), haha

Please post your makes! :D

Tags



Model origin

The author marked this model as their own original creation.

License