Cozy Christmas Tealight Fireplace

It's that time of year! With this fireplace you too can have your very own cozy decor piece. It sits perfect in almost any setting! You could take it to work for your desk, or put it in your school locker, maybe even on your fireplace mantle! The possibilities are endless with this tealight fireplace. 

Info:
I've spent many hard hours working on this model and I hope you will enjoy it. The only non-printed part of the model is a tea light. For colors I used; white, green, red, and brown. The entire model was printed in PETG. 

Print Settings: I would recommend putting supports for the front of the fireplace model where it overhangs, as well as underneath the logs. Other than those two models there is no other support material needed. As for the speed and quality, I printed at 0.2mm Standard Generic PETG. Wall loops is set to 4 but you could easily use 2. Infill was at 15% for all parts. I used tree supports for the front of the fireplace model, using 2 wall loops. As for the wood I used normal infill. Make sure your infill type is gyroid or similar if printing PETG. I have had good success with this infill type. 

Summarized Print Settings:
Supports Enabled
0.2mm Standard
PETG
Wall loops: 4
Infill 15%
Gyroid Infill
 

I hope you enjoy this year's Christmas! Happy Printing!

(Notice: This was originally uploaded to Bambu labs Makerworld just wanted to add it here as well to reach more people)