I needed a bracket for my new filament sensor: https://a.co/d/i49Ou13 which appears to be different than the once i found on here. Maybe a newer model, idk. I remixed my model from https://www.thingiverse.com/thing:3052488, but had to make many changes.
I hve a hard time figuring out which firmware to use with this filament runout sensor along with BLTouch. I think this one from creality website should work fine:
GD-Ender-3 Pro-HW-V4.2.2-SW-V2.0.8.23-CRTouch-FilamentEuropeMulti
Bearing dimensions: outside dia: 22mm x inside dia: 8mm x width: 7mm
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
20
Filament: overture pla black
Category: 3D Printer Accessories
The author marked this model as their own original creation. Imported from Thingiverse.