IKEA Ivar board no wooden parts for 30cm depht

With this model you can make some shelfboards which are compatible with an Ikea Ivar shelf. I made these because I have a door between two Ivar shelfs and I wanted to use also the space over the door, and because there was no Ikea shelfboard with the exact lenght I made my own. So if you have similar problems this might be the solution. Please follow the short Instruction below.

Instruction

• Attention this is for the 30 cm depth version of IKEA Ivar, here you can find the version for the 50cm deep one.
• Print the model two times, I changed the wall and the botton/top thickness so it's even more stable and printed it in PLA.
• Cut a board which is 18mm thick, 30cm deep and how long as you need it.
• screw the two parts at the boards, best you start with the screw in the middle, then the two outer screws, and then the last two screws.
• Now you can just insert the shelf board like the normal IKEA Ivar shelf boards.

hope you like the model, give me your feedback in the comments. 

best regards

mlax