Ravioli Maker / Mould and Pastry Cutter

A foldable Ravioli maker and additional pastry cutter
44
214
0
1224
updated July 28, 2024

Description

PDF

This is my second mould for use in the kitchen.

I felt I needed a Ravioli maker / mould after my intial creation of the Dumpling maker / mould available here: https://www.printables.com/model/656020-dumpling-maker-mould-updated-1212123

The Dumpling pastry cutter for the above is also available here: https://www.printables.com/model/660195-dumpling-pastry-cutter

This Ravioli maker / mould prints in place as a single print. When you remove it from the print bed, gently move it back and forwards a little at a time, until it folds closed… Then it is ready for use.

If you have any problems with it, then please let me know.

I have also made a Raviloi pastry cutter for it.
Use this to make a rectangle of pastry 45mm x 85mm no more than 3-4mm thick, just dont make it thinner as it won't seal and may split during cooking. The actual size of the finished ravioli is approx. 40mm x 40mm - the extra 5mm width is used in the well for the filling, so the 45mm x 85mm rectangle of pastry will end up 40mm x 80mm once filled and can then be folded.

The filling is approximately 1-2 teaspoons in size (of whatever you are using) to fill the ravioli properly. The 2 tabs that stick out are to help lift off the cutter and twist it to help cutting. They are also 4mm thick and can be used to put next to your rolled out pastry as a guide to make sure it is thick enough. The pastry should not be more than 4mm thick - The open top of the cutter is to make sure there is air above the pastry inside the cutter to ease removal after cutting.
 

 

Do you want to be able to sell any or ALL of my prints shown here on Printables.com?
If so, then click on the 'buy me a coffee' link below, (or click here) and join one of my memberships. This gives you the option of a monthly, yearly or lifetime commercial license, along with a certificate and loyalty bonus models (both commercial and non-commercial). The non-commercial items are 3rd party models that may also interest you, all in one place.
The lifetime membership offers you unique commercial items not available to anyone else as well as all of the loyalty bonus models.

 

Please click the LIKE (Heart) Button if you like my models. If you REALLY like them, then please also buy me a coffee at the bottom of the page. Thank you. 


 

Printing Instructions:

I printed these on my Creality CR-6 SE printer with Cura slicer 5.5.0 (Other printers/slicers can be used).

Material: PLA

Manufacturer: Prima Value

Colour: Light Grey

Resolution: 0.1 (First layer @ 0.2) / 0.2 for faster print (not as accurate)

Nozzle: 0.4mm

Print Speed: 80mm/s (First layer @ 50mm/s)

Nozzle Temperature: 210 Degrees

Bed Temperature: 65 Degrees

Infill: 10%

Supports: No

Skirt: Yes – x2

Brim: No

Raft: No / Optional

 

Enjoy your prints.

 

                           https://www.buymeacoffee.com/tigertone

 

Tags



Model origin

The author marked this model as their own original creation.

License