This cover protects from dust and shocks to some extent. It rests on the plastic edge so it would protect the knobs in a backpack or similar snug mean of transportation. It should fit any volca.
It's a bit of a loose fit (0.5mm on each side, so 1mm clearance).
I could reduce it to .5mm but I'm not keen on sharing a model I haven't actually printed and tested myself and this one will be fine for me.
It's designed to be printed upside down without supports with a .4 nozzle.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
10%, zig-zag
Filament: Chromatik PLA Transparent
Notes:
Sliced UPSIDE DOWN in Cura, .4mm nozzle standard quality with some tweaks :
* Min wall flow 30% * Fill gaps between walls : nowhere * Filter out tiny gaps * z-seam alignment : shortest * 10% infill in zig-zag * print speed : 70 mm/s
Category: Music
The author marked this model as their own original creation. Imported from Thingiverse.