
Hi,
I have the newer version of the original spool holder (molded not printed)
and therefore my screws a way to short!
Any chance you can share the source files so i can adopt them?
Getting M4 100mm seems a bit hard....
@TobiasStanzel_360119 yeah I can add the .blend file
@TobiasStanzel_360119 I have attached the .blend file. sorry I didn't see this sooner.
@cwbullet Thanks buddy!
added r3 and r4 of the spindles with taper so that the spools will tend to center themselves as they unfurl.
making an r2 of the left front and right. I needed slightly more clearance to allow the base to sit flush with frame when it's holding the enclosure acrylic down. Will post once I test print one. basically it's given 1.1mm more clearance, about the thickness of one of the zip ties prusa gives you. (edited)
I discovered after I printed a full set that the left rear one needed to be slightly different. I just added stl file for left rear and .3mf that contains all of them