MK4 Bin (two hooks)

Where to place your waste? Put it in this box. Nothing much to say here. Fits right into place. 

Essentially it is the exact same box as the one from mkoistinen. However, I do have to pick up my printer every now and then. With the original design only having one hook in the front, the box may fall of. In my case it even resulted in the one and only hook breaking off. So here is a remix with a secondary hook, which allows the box to stay in place when the printer is lifted. There is really not much rocket science here.

Important Note

Just like the original model this remix includes built-in supports for the hooks. However, based on community feedback these supports only seem to work well when printing in PLA. When printing in PETG, please take the model without built-in supports and use your slicer to generate support structures.

It is the same box, but with a secondary hook in the rear to allow the printer to be lifted up without the box falling (or worse breaking) off.