I created this remix for two reasons:
Printed on Bambu P1S, with AMS (for automatic filament switching), in 3 colours - black for the feet, then switching to white for the main body, and finally red for the hat. After printing, I used a marker to add accents to the face.
Printed well in PLA at 15% infill, 0.16mm layer height, no supports.
After printing, snap off the support tower under the hat and tidy up the edges if needed.
It mostly works at 50% scale as well, but the hook feels like it will snap off easily.
The author remixed this model.
Santa Hat - I made the brim of the hat taller, so that it ended at the same height as the bobble, to enable multi-colour printing with less waste.
Sheep - I added a hook for hanging on the back.
I then merged both models together to make the final decoration, additionally adding a small support tower for the bobble of the hat, which snaps off easily after printing.