Anycubic Kobra 2 Max Bed Level First Layer Calibration Squares Aligned with Bed Screws and Brim Test

Good

This shit printer have some problem. This is the second one (Anycubic send me a new afer the first with the same problem). Bed levelled with a dial, auto level done. And take a look pics!

AFTER WEEK OF TRY, I FIND THE SOLUTIONS! Take a look my post on reddit. its me.

 https://www.reddit.com/r/AnycubicOfficial/comments/1cfumwb/comment/l1wuiuo/?context=3 (edited)

I only used this to verify my newly-flattened bed, but it showed me exactly what I was hoping to see. I sized it down for my K2 Plus; even though the Plus only has six mounting points, it worked for my needs.

Thanks a lot mate, with your squares i could get an almost perfect first layer. Unfortunately the bed of the k2m isnt straight enough :X

Smooth enough 😊

Very good design and some effort went in to making these

I got "floating object part" Warning in Anycubic Slicer... But I would like to take advantage of this comment to thank you for all your files for the KOBRA 2 MAX, thank you very much.