Worked well. Shows my out of level.
Offset causes it to boot be useful for entire bed. Use care when moving as dial can exceed edge of bed.
Slip-on Dial Indicator Mount for Prusa Mk3s - No Modification or Disassembly Needed!
Simple dial indicator mount which slides on to the extruder motor and does not require any modification to the…
19
130
1
875
updated May 18, 2021
Makes
Comments
Super useless.... How to mount this two holes on side, but no horizontal hole for the dial... But anyway thanks
Not sure what the issue is? The upper hole is used as a set screw to hold the mount steady, and the indicator should be mounted in the bottom hole.
@Eric_140540I've printed and ordered the same dial. Can you add a picture of the dial mounted to the holder.
Seeing how I am an engineer, I like the instant feedback on the table and the independent confirmation of the SuperPinda.