Hello @ThreeDMichael , I would like to print these jars, but parsing the stl file them seem to be completely closed. Can you check, please? N.B. : Same thing for all 3 models.
@Odysseos It has to be like that. Please enable “Vase Mode” or “Spiral Mode” (name of this option depends on the slicer) for the jars (not for the lid!) as indicated in the printing instructions and follow the rest of the instructions.
@ThreeDMichael Hello. Thank for your fast answer. I apologize, I didn't read printing instructions. Now I'm going ti print the jar and then I'll post a Make. THX again
Hello @ThreeDMichael , I would like to print these jars, but parsing the stl file them seem to be completely closed. Can you check, please?
N.B. : Same thing for all 3 models.
@Odysseos
It has to be like that. Please enable “Vase Mode” or “Spiral Mode” (name of this option depends on the slicer) for the jars (not for the lid!) as indicated in the printing instructions and follow the rest of the instructions.
@ThreeDMichael Hello. Thank for your fast answer. I apologize, I didn't read printing instructions. Now I'm going ti print the jar and then I'll post a Make. THX again