Easy print support to hold your Amaizing g devil Fruits.
1h 40m
1× print file
0.20 mm
0.40 mm
34.00 g
Elegoo Neptune 3 Plus
33
206
2
1149
updated November 30, 2023

Makes

Comments

Neat model! Very helpful for holding devil fruits

printed and didn't fit together like puzzle pieces which I was expecting.

I was about to print them but then they are not here anymore

PLS ADD THE FRUIT MODELS BACK!!!
🙏🙏🙏

I decided to print another version of the Mera Mera no Mi for a friend of mine and took inspiration from the two colored filament @AXbeed used. The stand looks great with the other fruit as well, so it is more or less an "universal devil fruit stand"! Thanks a lot for the model!

I can't fit the stand parts on my Anycubic bed. Could you create a file with the parts set close together or three separate files, one for each leg of the stand? The fruit design looks really good and I'm hoping I can match it up with this stand. Thanks.

@AXbeed Thanks for the response. I reduced all the files to 75% to make it fit and it worked out fine. Was a good choice as I had just enough red/gold filament to complete the fruit part. Thanks again.

All comments loaded