Slot Bracket for Gotek board

This is a PC slot bracket that holds a Gotek floppy drive emulator in place at the back of a PC case.

Bill of Materials

• This print, of course
• Gotek board
• 3x Self-tapping screws for plastic, lens head, 3.0 x 8

Printing and Assembly

I used PLA, and printed with a resolution of 0.2mm, without rafts and without supports. For better stability, I recommend to use 100% infill.

The LED must be bent into the new position. Take care not to short-circuit the legs of the LED! If you don't need the LED, there is an alternative version without LED hole available too.

There is no space for the 7-segment display, as it doesn't make much sense on the back of a PC. It's better to find a way to mount the display (or an OLED display) to the PC front.