Raspberry Pi & Electronics Control Case

This is a component part of a 3D Printer enclosure project

It contains one Raspberry Pi 4 which runs Octoprint with PSU Control, Enclosure Plugins.
Rpi GPIO are connected to a breakout board with some electronic component to power (12v, 5v, GND) and manage properly:
2x PWN 120mm Fans
1x Neopixel 60 LEDSs strip (RGB)
4x Relay ports
3x 1-wire DS18B20 temperature probes

Print Settings

Printer: Prusa I3 MK3S

Rafts: No

Supports: No

Resolution: 200

Infill: 100

Filament: Prusament Orange PETG