The BLTouch I use was too low, it kept bumping into prints and especially the bed clips, so I made a model to raise it by 3.5 millimeters.
You should print this on it's side with supports!
This will offset the Z axis by 3.6 millimeters, X axis by 13.5 millimeters and Y axis by 0 millimeters. Be sure to do new Z probing afterwards still!
You can adjust this model in openSCAD!
To adjust the extra height, modify the extra_height variable. To adjust the thickness of the BLTouch mount, adjust bltouch_mount_thickness.
The author marked this model as their own original creation.