DUMMY 13 goes to COMIC CON - Emotional Deadpool masks

Based on DUMMY 13 Beta - Oct. 2023 

Some new emotions for my Deadpool costume: https://www.printables.com/model/627524

Print with 0,15mm layer height or less, no supports but use brim.

Slide the head into the mask and press it in with gentle force on the chin.

If this is not possible, it is probably due to the following points:

•  Check the inside of the helmet (the top) to see if it has been printed cleanly and remove any filament debris that is sticking out
• Has the brim been removed cleanly?
• The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife

Added new masks