Pomi

@Pomi

Cover replacement for Logitech C270 Webcam. Cover can be easily attached to any GoPro holder.

1h 16m

4× print file

0.20 mm

0.40 mm

PET

8.00 g

Prusa MK3/S/S+

146

746

4921

updated May 4, 2021

Raveniarty

@Raveniarty_1161140

I had a webcam lying around and I wanted to improve its look to use it in workshops. The look, with the yellow filament, is very original. Unfortunately, like others here, I had problems with closing the case. I had to use hot glue.

Storbi81

@Storbi81_372792

red and black filament from Amazon Basics. (edited)

Simon

@Simon_987357

I printed this, along with a couple of other bits, in Creality PLA CF and it came out really nicely. Thanks for the design

Christian

@Christian_

Will asamble it soon. Thanks for designing!

Cable management tightly

Compact clean design! I also had a little difficulty getting the case latches to stay closed, but I superglued it shut since I'm not planning on opening it up again any time soon.

PeteJ

@PeteJ

Good design which prints easily in PETG. Thanks for shrinking the camera into such a small case, with a flexible mounting system.

DSpecter

@DSpecter

I feel like the clips on the side could be .5mm longer, but works well. I removed the outside manual focus once I was happy with it, looks cleaner.

Pomi

@Pomi

@DSpecter I agree it looks it should be longer, but when I tried to change it, the tension was not enough and the cover was moving little bit. Maybe it also depends on some post processing. You can try to sand off the surfaces on cover and base part. (edited)