A customizable cable organizer that can configure arbitrary number and set of hexagon containers together, with differing heights.
For convenience, I've built out a wide number of different hex configurations for you to grab the ones that work for you. I used 1.5mm walls with 17mm sides.
Specify the size of a hex side, as well as your wall width. The cutout at the bottom is useful for cables if you need to push something through. For other cases, like a tool holder, this may be 0 so the bottom is 'wall' width.
To decide how many cells, you can specify an array of arrays, which is a little complicated. For those of you not familiar with programming, the easiest way to think of this is a grid. So laying out each inner array on it's own line is like the rows of a grid. Play around with a couple of configurations and I'm sure you'll get it.
After my last trip, I was cranky that my cables were such a mess, even though I put them in a plastic bag and wrap each one individually. I was inspired by some of the existing honeycomb designs, but none of them were customizable. So, much to my significant other's chagrin, I spent a Sunday putting this together. It's always fun to work on geometry and remember my trig.
Printer Brand:
LulzBot
Printer:
TAZ 6
Rafts:
No
Supports:
No
.5
Resolution:
.2
Infill:
20
Notes:
Print the shell at the same width you configure the wall size and infill won't matter (it's all shell).
The author marked this model as their own original creation. Imported from Thingiverse.