Caliper

STOP: DON'T PRINT THIS!! It's a waste of time and filament.

I designed it for the fun, for a competition, but it should be fully redesigned to make it work, and I am not going to do that. 

I print it on a Bambu X1 Carbon, in PLA tough, with a 0.6 mm nozzle and 0,18 layer height. Knob, screw and measure block to be printed upright, the end piece and the runner should be printed with support. See the 3mf file.

1. Put the screw in the measure block
2. Glue the knob onto the screw
3. Insert the runner and screw it into the measure block
4. Glue the end piece on the measure block

I use cyano acrylic glue, works wonders and is very cheap.