Sock Clips for Drying Rack - improved

This thing is based on Sock Clips for Drying Rack by lundiplutzmus

I made some improvements to save time and material and make it even better as it already was:

• reduced the overhang angle at the bottom of the rod clip
• deleted the teeth at the outside
• rod clips only for the first and last two pegs
• increased the gap between the pegs from 0.2 mm to 0.5 mm

Sure, a hook without a special diameter would also be good for some reasons, but I like the close fit, without having to hold it down, while attaching the socks from below. It is easy to customise in the OpenSCAD file.

Added sample files v3 with a gap of 1mm. Even 0.5 were tight.

Print Settings

Printer:

Zaribo MK3s 320

Rafts:

No

Supports:

No

Resolution:

0.3

Infill:

0%

Filament:

Signal Red

• reduced the overhang angle at the bottom of the rod clip
• deleted the teeth at the outside
• rod clips only for the first and last two pegs
• increased the gap between the pegs from 0.2 mm to 0.5 mm