- Take off the Printbed, unplug, unscrew and take off the heatbed
- roughen the heatbedmount carefully with sandpaper (the area for the stiffener)
- sanding the underside from the stiffener (the ribs) with sandpaper
- Clean all with Isopropanol and let it dry
- add superglue on the ribs from the stiffener
- glue the stiffener on the heatbedmount and press ist carfully a few seconds
- reinstall the heatbed and the printbed and dont forget to levelling your printbed!!
- before reassambling you can compensate unevenness in the heatbed by add some washers if necessary (in my case on the left front edge).
Print with sturdy material (PLA+, ABS, ….), 4 Walls and 20% infill.
Tags
The author marked this model as their own original creation.