Glasses for celebrating the New Year.
3h 4m
4× print file
0.20 mm
0.40 mm
31.00 g
27
189
5
1156
updated December 17, 2023

Description

PDF

Glasses that you can bring to spice up any New Year's party. Note I only have a model for the left side arm, mirror it in the slicer to create the right side arm. I usually print the arms standing up on the top edge using a small amount of support for the top shelf. They can be printed on the larger flat side with no support but that puts the layer adhesion under the most stress, so double check that they don't break when forced a little. See my pre sliced g-code below and you can decide which orientation works best for you. The face just prints on the large flat side.

As far as rivets to hold the arms in I cut a piece of filament (about 26mm) and form the ends into heads using a soldering iron. It's a good use for those small bits of filament at the end of a roll. (see the pictures for what the rivets look like.) You can also check out my rivet cutter tool for extra help https://www.printables.com/model/683199-rivet-cutter-tool.

The number one question I get with these glasses is “can I see with them?”. The answer is mostly, I can see about 90% through them. I get slightly blurry vision. Some people with impaired vision may have more difficulty. Wear at your own discretion.

Tags



Model origin

The author marked this model as their own original creation.

License