Filament Rack With Aluminum Pipes Or Broom Handles

Filament rack with aluminum pipes or broom handles with a diameter of 23,5mm.
3h 48m
1× print file
0.20 mm
0.40 mm
167.00 g
4
34
0
196
updated November 11, 2023

Description

PDF

Filament rack with aluminum pipes or broom handles with a diameter of 23,5mm. The distance between the pipes or broomsticks is exactly 120 mm in the middle. 

The length of the tubes is 50 cm in my case, but can certainly be extended to 100 cm, if not more. Please try carefully because of the weight.
To protect the filament rolls from falling down, caps are glued to the ends of the tubes or screwed onto the broomsticks.

There is a remixed model of a filament dispenser that fits exactly on this rack here, from which the filament can be used directly on the 3D printer, if space permits.

Parts to be printed:
- 2x rack support
- 4x end cap for tube or broomstick

The following additional materials are required: 
- 4 Spax screws (approx. 3.5x25) to screw the 4 caps onto the broomstick or some superglue if the end caps are glued to the tubes
- 4 dowels 8 mm if stone or concrete wall, or other dowels for e.g. plasterboard wall
- 4 screws for wall mounting, approx. 5x40
- 100 cm aluminum tube or broomstick, diameter 23.5 mm, separate into 2 parts of 50 cm each, or choose another length

The following tools are required:
- Phillips screwdriver
- Drill with masonry drill bit or wood drill bit, depending on the condition of the wall
- Saw for wood or aluminum

Tags



Model origin

The author marked this model as their own original creation.

License