recomend, very well modeled
My optimized dry-box set for Bambu Lab AMS
My optimized dry-box set for Bambu Lab AMS, incl. funnel for easy handling
66
762
14
3144
updated November 9, 2024
Makes
Comments
@Qeepo Thanks!
Best version of the AMS desiccant containers no doubt. I’ve printed several versions so I would say I know what I’m talking about. There is still some room for improvement thou, the hygrometer version doesn’t really print that well in ASA, I guess in PLA it’s better because of the better bridging. The small containers on the side didn’t fit 100% in my AMS, I cut of 3,5mm of the tabs to fix it. Either way, thank you very much for making this, it’s awesome!
View 3 more comments
@Slanjonok no worries at all! I understand that this might be more an issue with the filament but making it in ASA has the advantage of the additional temperature resistance to dry the desiccant straight in the container. I’ve attached a photo of how I printed it.
@Muffelkraft Yes, but this needs quite good bed adhesion, even with brim... however the idea to use ASA to make drying inside the contaier is quite interesting.
Thanks again for sharing.
Works nicely and fits perfectly. The small ones on the sides are a little bit tricky to put them into the AMS, so DO NOT use force. ;)
Love this set! Had the ams open for a few, but I expect it'll dry right up shortly thanks to all that AA packed in there. Printed in PETG+. Came out great. (edited)
Printed really well, and the hygrometer fit perfectly. I have shared a remix that prevents the two outer boxes from tipping back in the spools. I did not use the smaller boxes.
This is a great design and will hopefully keep the humidity down!
@ReiLi_1622412
Nice print, but 52%!
You need to put silicia gel into, doesn't work without! ;-)
EXCELLENT design! Printed all the boxes, funnel, etc. All the boxes, I did in transparent PETG so I can monitor the desiccant color. Fit the hygrometer perfectly also. Printed with tree support and worked out perfectly.
Really excellent model. I was nervous about all the detail and bridging, but it printed like a dream in PLA-CF -- super impressive. My AMS has been dead-locked to 10% humidity (hygrometer minimum) for almost 2 weeks when packed to the gills with silica gel desiccant from this design plus the rear pods, plus jars in the center of each spool.
Hello:
when I slice the hygrometer integrated box, I keep getting warnings that it needs supports to print (P1S, Bambu Slicer) "floating cantilever...". This is regardless of orientations I have tried. Do you have a print orientation that you recommend to avoid using supports? Thanks
View one more comment
Although I like Printables and prefer - unfortunately, pre-sliced print profiles for Bambu Studio cause problems on printables. You may find the ready to print profile on MakerWorld.
@Slanjonok Thank you!
The model has enough space behind the hygrometer for better airflow, and fits well to the AMS attached.
Also, I like that the hygrometer is at a higher level than other models and looks a bit upward. It has one of the biggest volumes for silica gel among comparable models.
@PPutnik_1802000 Happy to see your print... The volume is coming from Zerginator's version, so the honor belongs to him... you may consider to give him a like! ;-)