This was made on Tinkercad
Supports Yes
20% infill
0.2 layer
You may want to scale the hanging piece slightly smaller so it fits into the base a bit better
How to assemble
For the hanging piece there is a hole on the base glue in place
Look at the first picture for where to put the bridge
There is an arch too glue that on one side of the bridge
There is a big hole near the middle that is where you put water or other plants
Everywhere else place sand, plants. dirt, rocks, make this garden yours!
You could even put a fountain in the water spot too.
Post your makes and other comments please!
The author marked this model as their own original creation.