ESP32_Cam mount for Prusa enXLosure

mount to add a ESP32 camera to the inside of the prusa enXLosure
35
149
3
1234
updated November 3, 2023

Description

PDF

I wanted a camera inside my prusa enXLosure to connect to prusalink/ -connect.

For this upgrade you will need;

- ESP32-CAM module
- 1x M3 Heatset insert
- 1x M3x8 bolt
- Micro-USB cable (best to get right-angle)
- USB powerbrick
- You will need to print the "EnXLosure_Bottom_BR_cableguide" version or drill a hole in the corner of the part to route the power cable thru the frame

 

Installation;


 

Step 1; insert the M3 heatset insert to the first heatset hole on the inside of frontright corner.

Step 2; Place the ESP32-CAM module in the 3D printed housing. (base)

Step 3; Install the front cover of the ESP32-CAM module.

Step 4; Instal the assembled module in the front right corner of the prusa enXLosure.

 

Step 5; Insert te micro-USB and route it thru the side and out of the rear of the enXLosure.

 

Software;

For installation of the camera software, please follow the setup found here

config for software;

Please turn on both "Hmirror" and "Vflip" to get correct orientation

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

Adapted the base to mount inside the enXLosure

License