Replacement center vent for BMW e36 in the following configurations:
I have only printed the 2 52mm gauge version. All of them should work, but I'm not positive on the 3 52mm gauge one. I used a ziptie on the shorter mounting tab to the screw hole on the top of the radio to pull the left end in a little, otherwise it sticks out a bit.
PLA will melt in the sun. I printed in PETG and finished it off with suede flocking and it's been fine.
There's a .3mf file in case edits need to be made. The model is pretty hacked together, but hey, it prints!
Thanks to https://www.thingiverse.com/vague_badger/designs for the original design that I based this off of.
Category: AutomotiveThe author marked this model as their own original creation. Imported from Thingiverse.