ImpulseRC ApexEVO GoPro 9/10/11/12 Mount

I liked the original design because of its clean surfaces and edges. I've just tweaked it a little bit and added the base for the ApexEVO frame.

!IMPORTANT!{begin}

The gap between the front propellers and the mount is about 6mm. I haven't experienced any issues yet, but I think it might be possible for the propellers to bend and touch the mount under heavy load (e.g. recovering out of a dive). The angle should prevent the propellers from cutting into the TPU but I've also made a version with a 5 mm higher base. 

!IMPORTANT!{end} 😉

• added the base to fit the ApexEVO frame
• overlapping frame around the lens protects the lens / the nd-filter
  • a cut on the upper side makes sliding in and out the GoPro easier. It also has a reinforced end to prevent the material from tearing
• made all indicator lights of the GoPro visible
• closed the holes for mounting. It's printed in TPU, you can easily bend the part to access the screws
• 20° angle