Collapsable Draw Bridge Doorstop

If your house is your castle than where is the draw bridge? Wel now its holding your door!
7h 8m
3× print file
0.20 mm
0.40 mm
Flex
PLA
63.00 g
In the contest Door Stoppers
35
47
0
906
updated October 30, 2023

Description

PDF

Printing

Layer Height 0.20mm or lower

No supports needed

Material: TPU and PLA (I used a mat PLA but most types should work)  

Perimeters: The TPU part 4 or more others can be juist 2

 

Assembly/Installation

begin by pushing in the TPU part into the bridge but don't push on the hinges it can be a bit tight if you had some stringing make sure it is all removed otherwise it will not fit

Can be screwed in place with 4 3.5mm countersunk screws or adhered with double sided tape on the "gate" pieces after adding the bridge

 

If your going to screw it in place. Pinch at the top when screwing in the second screw. Because there are dimples on either sides to hold the bridge up. now you can screw in the bottom two

combine the two gate pieces and push it on the bridge while the bridge is horizontal.

 

 

 

 

 

 

If your going to adhere it to a door, you can juist assemble it beforehand and add tape afterwards 

Installation

the bridge should be nearly or completely down with the TPU part digging into the floor

 

Bonus

on top there is a slot for 1x8 brick plate

Tags



Model origin

The author marked this model as their own original creation.

License


Highlighted models from creator

View more