Meta Quest 3 Controller Grips - Sports / Active Strap Mod

Quest 3 Controllers - Sports / Active Strap Mod

This is my mod to reuse my 14mm wide velcro straps (from my quest 2), it'll fit anything up to that (10mm on aliexpress recommended if you don't have the ones from the aftermarket quest 2 kits)

Version A - For velcro strap up to 14mm

Version B - For Paracord (up to 5mm) or to use with the stock cords

Required Materials

• PETG filament (recommended due to it's flexibility)
• Hook Loop Velcro Strap - 10 to 14mm [Aliexpress]

Printing

• Use 0.12mm layer height, thin wall detection and supports where needed
• (Printing profile for BambuLab printers on MakerWorld)

Preparation

• Remove supports and sand the parts if needed

Assembly

1. Open the controller by pressing the button to eject the controller lid
2. Slide the bottom part (the one where the cord is attached) out
3. Insert the clip on the controller by sliding it
4. Insert the printed controller cover
5. Put the strap in place