QUICK-CLIP: T-Handle Locking Pins

NOTE: This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"

Post-Processing Difficulty: Easy (Ready to Use from Printer)

Tools Needed: None

Introduction & Instructions:

QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a variation of the standard and captured locking pins with a T-Handle, which can be more easily grabbed while wearing gloves. It is designed to go with the base started set (found under my profile). It is attached to and removed from the mounting system in the same way as the original locking pins.

I printed it with 0.16mm layer lines with PLA with no supports or brims.

Hope you enjoy!