FPV cam + transmitter case with strap-mount

Use Case:

This case is meant to be used with a 1500TVL B19 fpv-cam  and a TX2500 V4 fpv-transmitter.

It can be secured to the strap of a backpack or a pole to make a portable or stationary fpv-cam streaming/surveiliance setup. It is powered with an external battery pack.

Material-List:

You will need the following Materials:

Assembly:

1. Print the two parts of the case, clean them of stringing if necessary (scalpel or heat gun).
2. Insert the Camera, screw it in with the screws that come with it.
3. Wire up the connectors of camera + transmitter according to the instructions on the transmitter AliExpress page (add power wires to go to the expternal battery pack. I soldered a XT60 connector to the end)
4. Connect the connectors to camera + transmitter
5. Insert the transmitter
6. Feed the power cables through one of the holes in the case, fixate them with hot glue
7. Push the screws through from the front
8. Feed the two velcro straps through the pack plate
9. Put the back plate on and screw it down using the nuts