Project Enclosure 100 mm x 150 mm x 40mm

Project Enclosure 100 mm x 150 mm x 40 mm

• Separate compartments for power supply and electronics.
• 4 versions with different combinations of vents and mounting holes.
• Lid screws into M4 heat-set nuts.
• Mounting holes are M5.
• Rigid Grommet has more clearance for the walls of the case. The darker grommets in my photo are TPU 82A.
• M4 and M5 Countersunk washers from my Countersunk Washer Library included.
• Photos show an earlier revision with marginally different mount geometry, and without stress-relief rounding along the internal edges.
• Expect an 8-12 hour print for the case plus 1-2 hours for the lid, depending on settings.